School chair protections

Price

• Custom design (measurements required)

• 5 € per piece "the essential"

• 5.5 € per piece "the essential - extra protection"

• 6 € per piece "Double lock"

• 10 € the pair of pieces "Generic system"

• Minimum a pair of two pieces for a chair

• Shipping costs apart

• Not valid for using on floor with great resistance (carpet, cement, ...)

Taking measurements for a chair

We remove the rubber bands on the legs that prevent us from taking the measurements correctly and placing the device.

We put the chair on the edge of a table that we will have previously protected to prevent it from being damaged.

The legs should be in line with the edge.

Since we want to measure the rear angle of the rear leg, we place the chair with the side legs in line with the edge of the table.

Next we put a ruler, square or bevel glued to the side of the leg for which we want to measure the angle and then with an angle protractor we measure the angle (85 degrees in the image for the rear angle).

The angle may vary with the weight of the person sitting.

Some chairs like the one in the image have two angles.

• Backwards (normal)

• Towards the side

In this case you must also take the measurement of the lateral angle.

It will be done in the same way as before but you have to turn the chair so that it is on its back with the rear legs in line with the edge of the table (95 degrees in the image below for the side angle).

Finally, send an email or fill out the contact form indicating:

• rear angle

• Lateral angle (if applicable)

• Diameter of the base of the leg (if it is round)

• Width and depth of the base of the leg (if not round)

• Desired quantity

• Shipping information

• Photos are a plus

• Desired payment method (transfer or cash on delivery)

Contact

Do you have any questions about our protections? Contact us today for more information!

Safe School Seat

We manufacture custom protections for school chairs to prevent children from falling.

Location

Amadora (Portugal)